Instructions to fix the kickstand problem on early PCII's

1. Remove electrical tape from PCII wiring harness

2. Locate the solid "black" wire that goes into the
main gray sleeve of the PCII harness.

3. Cut this wire about 1" from where it exits the gray sleeve.

4. Using a butt connector & crimpers attach a new wire to the
PCII side of this wire with a 1/4" eyelet on the other end.

5. Attach this new wire to a bolt on the frame to ground it.
(I used the bolt that holds the undertray to the subframe in the
far back right hand corner of the tailsection)

6. Retape harness.

bike will now start with the kickstand down